![]() ![]() Stiffeners (1034): Previously, the welds between the stiffeners and the part were created in an incorrect position. Metsec File transfer (26): Metsec apex strut CAM data is improved to allow for situations when purlins are set between or below the rafters. When none of the cover thickness values are defined, the default cover thickness is used.įloor layout: The CIP filler part is no longer created outside the component polygon boundaries. ![]() Mesh bars, Mesh bars by area: When the cover thickness values for the openings or recesses by cuts are not defined, the cover thicknesses for rebar ends defined on the Bar end condition tab are used instead. Previously, the global orientation was taken into account, and this caused rotated pad footings with starter bars to have different numbering. Starter bars for footing (87) now takes the local plane of the pad footing into account. Previously, if you had the insulation layer as the lower layer and changed the line up direction, the insulation was not created correctly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |